Single-family and multi-tenant IP video door stations, wired to the gate or door operator and built into the smart-home or NVR platform you already run.
DoorBird is the IP video door station for a property already running a smart-home or private-server platform. The stainless panels take exposed gate and entrance mounting, and the open API is why integrators pick them — the intercom becomes part of the system instead of a walled-off app.
We install and service DoorBird stations, wire them to the gate or door operator so entry is credentialed and not just answered, and set them up so a dropped internet connection never leaves a visitor stuck at the gate.
That's one layer of five. See access control for the full scope, or browse the other brands we work with.
The lines we work with most. Don't see yours? We can almost certainly still support it — ask.
Single-call surface or flush IP video station for a house or one entrance.
Expandable panels with add-on call buttons and keypad or reader modules for small multi-unit sites.
Stainless directory panels for residential and commercial buildings up to 500 units.
Companion controller for driving a strike or operator and managing local credentials.
Integrates with Control4, Crestron, ELAN, RTI, URC, Loxone, Synology and QNAP, plus standard SIP platforms.
Panel mounted, PoE run, wired to the gate or door operator, sealed for the location.
Tie the station into your smart-home controller, NVR or SIP system so calls and door release run through the platform you already use.
Dead panels, PoE and wiring faults, failed door controllers, app and call-routing problems, water intrusion on exposed mounts.
Adopt a DoorBird installed without integration, connect it properly, and document the accounts and API keys.
Straight diagnosis, a written quote before we start, and the common parts already on the truck. Here's how a repair call runs.
App notification or SIP registration failure, often after a router or firmware change. The panel is fine — the routing isn't.
PoE injector or switch-port failure, or a water-damaged cable on an exposed mount.
A failed A-series controller, or a relay wired with no local fallback.
Condensation behind the lens on a panel that wasn't sealed right at install.
API credentials or a third-party platform change. We re-authenticate and re-map the events.
A DoorBird station shows you who's at the entrance. Wire it to the gate operator, back it with local credentials, and record it with the camera on the same point, and the call becomes a logged, verified entry. That's the Complete Security Gate System.
Based in Santa Clarita, dispatched across Los Angeles, Ventura and Kern counties.
The panel and its wired door release keep working locally. You lose app calling and remote unlocking until the connection returns, which is why we always add a local fallback — a keypad, reader or on-site handset — for that case.
Usually, yes. The gate operator takes a contact input, and a DoorBird A-series controller or the station's relay can drive it. We check the operator and its safety devices first.
Yes — DoorBird's open API covers Control4, Crestron, ELAN, RTI, URC, Loxone and more, and we set the integration up rather than leaving it app-only.
Yes. The D21DKH and D21DKV directory panels are built for multi-unit residential and commercial properties up to 500 units, with per-resident app access.
New install, integration, or a system that's stopped working — tell us what's on the property and we'll price the work.
We protect people, property, and peace.
