Residential linear arms, commercial slide and swing operators, the Elite Series — installed, tied into access control, and fixed fast when they quit.
LiftMaster is the operator we get called about more than any other — because it's the one already on most Southern California driveways and commercial entrances. Residential linear arms on thousands of homes, Elite Series slide and swing units running apartments, HOAs and industrial yards.
New install, integration, or a gate that's stopped moving — we handle all of it, on LiftMaster gates we built and ones we didn't. We stock the parts that fail most, so a dead board or a bad capacitor is usually a same-visit fix.
That's one layer of five. See gates for the full scope, or browse the other brands we work with.
The lines we work with most. Don't see yours? We can almost certainly still support it — ask.
24VDC residential swing operator for leaves up to roughly 16 ft and 550 lb, with soft start and stop.
Higher-duty swing operator, 300 cycles a day, single-phase 115 or 230V.
Commercial DC swing and slide operators with battery backup and 90° travel in 13–15 seconds.
Commercial and industrial slide operators for high-cycle vehicle traffic.
Solar-capable DC operators for sites with no power at the gate.
Operator matched to your gate's real weight and traffic, safety loops and photo eyes to code, battery backup and manual release every time.
Keypad, intercom, card, plate reader or phone entry wired straight to the operator — every entry credentialed and logged.
Boards, capacitors, limit and force faults, dead safety devices, burned-out motors — diagnosed on the spot, quoted before we touch anything.
Adopt a LiftMaster gate from an installer who's long gone, document it, and get you back on a maintenance schedule.
Straight diagnosis, a written quote before we start, and the common parts already on the truck. Here's how a repair call runs.
Nine times out of ten it's the close photo eye — knocked out of alignment, a spider web, or sun glare. Realigned or replaced and you're closing again.
A failed run capacitor. Cheap part, ten-minute fix once we've pinned it down.
Open and close limits have drifted, or a limit switch is worn. Recalibrated in one visit.
Surge damage. We swap the board and check the transformer and grounding so the next storm doesn't repeat it.
The operator was sized for a fraction of the cycles your gate actually runs. The fix is the right-sized unit, not a third replacement board.
The operator is the muscle. Add access control, a camera on the same entrance and a network that stays up, and every entry comes with a name, a timestamp and video. That's the Complete Security Gate System.
Based in Santa Clarita, dispatched across Los Angeles, Ventura and Kern counties.
Yes — most LiftMaster calls we run are on someone else's install. We diagnose the board, motor, limits and safety devices and hand you a written quote before any work starts.
For most residential and light-commercial gates it's a solid choice, as long as it's sized correctly. Repeat failures almost always trace to an undersized operator, not the badge on it.
Yes. The operator takes a simple contact input, so a keypad, intercom, reader or phone-entry system can drive it — and you can retire the clickers entirely.
It's a security gap more than a hazard, and it's usually the close photo eye. We get out same-day for a gate stuck open and realign or swap the sensor.
New install, integration, or a system that's stopped working — tell us what's on the property and we'll price the work.
We protect people, property, and peace.
